Abt 2 beams active photoelectric detector with digital frequency covnversion installation guide.
1 on working mode(non-programming mode), press programming switch, can open or close signal strength indicator. Open signal indicator when adjusting,after that ,close indicator for saving power . Switch tra/rec dip1 dip2 dip3 dip4 dip5 frequency switch no no buzzer switch power dc13.8v-24v(non-polar...
2 50mm 50mm . Precautions for setting impediment presents during setup re ce iv er tr an sm it te r re ce iv er tr an sm it te r multi sensors may be used for long-distance guarding. Please install according to the below diagram to avoid interference between beams. The base is unstable re ce iv er t...
6 setting of transmitter data 1 2 3 4 frequencies selection 3 power power off on off on tamper tamper 7 7 8 8 1 1 2 2 3 3 4 4 5 5 6 6 nc nc frequency list dip 1 2 3 4 5 6 7 8 1 2 3 on off on off on off on off off on on off off on on off off off off off on on on on empty 240 240 50 50 response time a...
4 installation of fixed bracket 8.1.Drill a hole on the bracket and extend out the cable from it. 8.2.Remove the cover. 8.3.Fasten the base-plate to the bracket. (back-to-back installation guiding diagram) 8.Put on the cover after adjusting the response time of the beam. . Beam alignment 5.2.Adjust ...
5 min max green led light up shows transmitting transmitting in anti-fog state transmitter and receiver are not in same frequency state led on,alarm led on state led off,alarm led off beams are blocked,alarm state state led off,alarm led on state led on,alarm led off normal state . Beam response tim...
6 trouble checking fault cause solution check the power wiring the led of the transmitter doesn't light up power failure (open circuit, short-circuit, etc.) check the power wiring the led of the receiver doesn't light up power failure (open circuit, short-circuit, etc.) 1.By reflecting, or light fro...
