ABYSSOUND ASP-1000 User Manual - page 10
P a g e
9
„INPUT” knob is used to choose the input. When switching between the inputs, a
temporary silencing of the preamp output is expected.
„DIRECT” input bypasses the preamplifier volume control to allow use in 5.1
surround system devices equipped with their own volume control.
WARNING!
„DIRECT” input bypasses the preamplifier volume control (it carries
the full input signal to the preamp output).
Plugging in a source without its own volume control to this input may
result in damaging the loudspeakers.
The user can set an appropriate damping level, independently for each input (with the
exception of the „DIRECT” input), with the „GAIN” control knob.
The microcontroller memorizes the settings, so there is no need to adjust them to a
changed input, or when the device is turned off and on again.