AC Mobility Traxx 2 User Manual - page 17
AC Mobility
User Manual for the Traxx 2 2 electric wheelchair
September 2009
Page 17
Adjusting the seat width
1. remove any backrest system or
upholstery attached to the backrest
frame.
2. remove any seating system or
upholstery attached to the seat base.
3. remove the 2 fasteners on the front and
the 2 fasteners on the rear crossover
brackets that control the seat width (see
illustration)
4. determine the required seat width
5. adjust the side rails and backrest frame
to the desired width, one side at a time.
6. replace the fasteners, being careful to
ensure they are firmly tightened so as
to not undo but please avoid over
tightening them
7. insert the seating and backrest system
or upholstery and attach as required.
Note : if using a “drop in” seating system, please check that the seating system does not
obstruct other chair functions.
Adjusting the backrest angle
The backrest can be adjusted to a wide range of angles, the range being determined by the
seat depth selected. The adjustment is done as follows:
1. loosen the backrest recliner nut on each side of the
chair (see illustration)
2. tap the nut to loosen the setting
3. adjust backrest to the desired angle
4. retighten the backrest recliner nut on each side of the
chair
Adjusting the armrests to the correct position and height
Adjusting the armrest pad position relative to the front of the seat
1. determine the desired position for the armrest pad from the front of the chair
2. remove the armrest from the side rail armrest attachment bracket by loosening the
turn wheel on the side rail (see illustration below)
3. turn over the armrest and loosen the fasteners attaching the armrest pad to the
armrest post. If necessary, remove the fasteners and reposition the armrest pad so
as to allow an increased range of movement.
4. move the armrest pad to the desired position, retighten the fasteners, being careful
to ensure they are firmly tightened so as to not undo but please avoid over
tightening them
5. replace the armrest into the side rail armrest attachment bracket & retighten the
turn wheel
Recliner nut
fastener