AC Mobility Traxx 2 User Manual - page 19
AC Mobility
User Manual for the Traxx 2 2 electric wheelchair
September 2009
Page 19
Positioning and adjustment of the controller
The standard controller can be positioned on either side of the chair. This can be achieved
as follows :
1. place the controller bracket into the
controller support tube (see illustration)
2. set the controller to the desired position
for the client
3. tighten the grub screw to hold the
controller bracket in place
Folding the backrest for transport or storage
1. check that there is clear space that will allow the
backrest to fold between the armrests, removing any
obstructions if necessary
2. remove clevis pin in the backrest recliner support
rod on each side of the chair (see illustration)
3. fold the backrest forwards. You may need to remove
the armrests to fold completely flat.
Note: if transporting the chair, you may wish to protect the
controller to prevent damage
Fitting of other seating and backrest systems
There are many different styles of seating and backrest systems available. Before
attempting to fit the desired system, you may need to fit the Commercial Backrest Tube Kit.
This is an accessory kit and is not supplied with the chair as standard. Please check with
your dealer in regard to the seating system you wish to fit and the backrest tube
requirements for it.
Clevis pin
Controller
support tube