Acano Solution Installation Manual - page 11
Network Configuration
Acano solution: Installation Guide 76-1002-04-D
Page 11
4 Network Configuration
4.1 Creating an Administrator Account
17. Connect power:
AC power option: connect both power units to the AC mains using the appropriate power
cables for your location. There are no on/off switches; therefore the Acano Server
powers up immediately
DC power option: switch on the DC power to the Acano Server
18. Moving to the front of the server (see Figure 1), you see the two power unit status LEDs and
the server status LED are on, indicating that the Acano Server is powered and operational.
19. Connect the Acano Server Console port to a terminal emulator using the serial cable
supplied in the box. Use baud rate 115200, 8 data bits, no parity and 1 stop bit
Note: Be sure that the login prompt is displayed before proceeding, otherwise the server
may still be booting up.
20. Using a Philips screwdriver loosen the two screws on the top front service hatch and hinge
the cover upwards.
You see the fan module on the left and a smaller area on the right with cables and
connectors. In this area and behind the front grill are two small buttons: one red (labeled
reset) and one black.
Figure 5: Location of the red button
21. Carefully press the
red
(reset) button only.
22. Within 4 minutes of pressing this button log into the Acano Server using the terminal
emulator: user account is
“admin”, no password will be requested.