Acano Solution Installation Manual - page 12
Network Configuration
Acano solution: Installation Guide 76-1002-04-D
Page 12
23. Set up your admin account using the following command.
user add admin admin
24. You will be prompted for a password which you must enter twice.
25. Close the hatch and push the screws down to secure the hatch, no screwdriver is needed.
Note: When you log in subsequently, either via the Console port or Admin interface, using the
admin account you will be asked for this password.
4.2 Setting up the Network Interfaces for IPv4
26. Configure the Network Interface speed
To set network interface speed, duplex and auto-negotiation parameters use the iface
command e.g. to display the current configuration on the Admin interface, type:
iface admin
where “admin” is the Web Admin Interface. In the examples below “admin” can be
substituted by “a” (the A interface) to re-use the commands to configure that interface.
To set the Admin interface to 1GE, full duplex type:
iface admin 1000 full
and to switch auto negotiation on or off, type:
iface admin autoneg
We recommend that the network interface is set to auto negotiation unless you have a
specific reason not to.
27. Configure the IP settings:
a. Go on to step c if you are using static IP addresses.
b. Configure to use DHCP
To enable dhcp on the Admin interface type:
ipv4 admin dhcp
Note: There is a similar set of commands to use if you are using IPv6. See the MMP
Command Reference for a full description.
Then to find out the dhcp configured settings, type:
ipv4 admin
ipv4 a
Go on to step 28.
c. Configure to use static IP addresses (skip this step if you are using DHCP)
Use the IPV4 add command to add a static IP address to the interface with a specified
subnet mask and default gateway. For example, to add address 10.1.2.4 with prefix
length 16 (netmask 255.255.0.0) with gateway 10.1.1.1 to the MMP, type:
ipv4 admin add 10.1.2.4/16 10.1.1.1
To remove the IPv4 address, type.