AccuLine 40-6500 Instruction Manual - 6. Operating Instructions
©2005 Johnson Level & Tool
7
6. Operating Instructions
IMPORTANT: It is the responsibility of the user to verify the calibration
of the instrument before each use.
Battery Installation
Note: Always check to be sure that the
on/off switch is in the off position before
removing and replacing batteries.
1. Turn the instrument by 90 degrees.
2. Remove the battery door.
3. Put in four AA alkaline batteries into the
battery compartment, noting polarity (as shown).
4. Snap the battery door back into place.
Note: Do not charge alkaline batteries to avoid explosion.
Used (discharged) batteries are hazardous waste and should be
disposed of properly.
Instrument Usage
Horizontal Output Status Instruction
1. Put four “AA” alkaline batteries into the instrument or power the
instrument by connecting DC 6V through power jack.
2. Mount the instrument on platform or a leveling tripod, connecting
with tripod by the 5/8" –11 screw thread.
3. Make sure that the grads adjusting knob points to 0 scale.
4. Adjust leveling-knob to center the bubble of vials both in X and Y
direction.
40-6500_6510 English 4/11/05 2:23 PM Page 7