Accurate Technology ProScale User Manual - Ection
ProScale RF Receiver User Manual
Page 14 of 20
S
ECTION
4
O
PERATION
Command Format Examples
The following examples demonstrate how to configure various parameters of
the ProScale RF receiver system.
If an invalid command letter is entered, the receiver will provide the following
response:
Use t, s, o, d, v, b, m or e.
Upper case to edit, lower case to view.
System ID
To display the current system ID type in:
s
The receiver responds with:
System =
(Factory Default = 0)
To change the system ID to 21, type:
S21
The receiver responds with:
System now = 21
Output Mode
To display the current output mode (from default), type in:
o
The receiver responds with:
Output Mode =
(Factory Default = 3)
To change the output mode to 4, type:
O4
The receiver responds with:
Output Mode now = 4
Delimiter Character
To display the current delimiter character (from default), type in:
d
The receiver responds with:
Delimiter =
(Factory Default =