AccuRelief ACRL5500 Instruction Manual - Step 3 - Turn On The Device

12

POWER

x10000

x100

COUNTER

Step 3 - Turn on the device

To turn on the device. Press the power button 

[     ] on the device or use the remote control.  

In the default setting, the display lights will read 

[     ] 30 minutes, [     ] 00 output intensity, [    ] 

00 output intensity.

DIRECTIONS FOR USE

Foot and Leg Stimulation (         )

Step 1 - Place the device on the floor.

Place the device on the floor, a comfortable 

distance from your chair. Sit down on your chair 

while maintaining 90 degrees at both knees.

WARNING: Never stand on the AccuRelief 

Ultimate Foot Circulator.

Step 4- Setting the treatment time

Using either the remote control or buttons on 

the device, set the treatment time by using the 

[      ] button. The treatment time is adjustable 

between 5, 10, 15, 30, 60 and 90 minutes as 

a cycle.

Please note: If you want to do 

combination foot and body stimulation, 

skip Steps 5 & 6 and go directly to Step 

1 of Body Stimulation (    ) on page 14.

Step 2 - Place both bare feet onto the 

footpads.

Remove all socks and stockings and place bare 

feet onto the footpads. The arch of your foot 

should be positioned on the raised instep on 

the footpads. It does not matter if your feet are 

smaller or bigger than the footpads, as long as 

pressure is on the instep.

Both the footboards of the AccuRelief Ultimate 

Foot Circulator can tilt back and forth. This 

gentle and involuntarily feature creates ankle joint 

movement for increased circulation.

CAUTION:

• Two feet are required to create the 

stimulation.

• Sit with your knees both at a 90 degree angle.

POWER

x10000

x100

COUNTER