Airmar H2183 Owner's Manual & Installation Instructions - page 10
10
Attaching the Sensor to the Bracket
1. Feed the cable through the mounting bracket (see Figure 3).
2. Align the word “forward” pointing forward and parallel to the centerline of the
boat while holding the gasket firmly against the sensor.
a. Studs—Push the studs through the mounting bracket. Fasten the sensor to
the bracket with a flat washer, a lock washer, and a thumb nut (with the metal
side against the washer) on each stud. Hand-tighten only. Do not over
tighten.
b. Screws—Place the senor on the bracket, being sure the screw holes in both
the sensor and the gasket are aligned. From the underside of the bracket,
fasten the sensor with the two flat washers, lock washers, and brass machine
screws supplied.
3. Be sure the word “forward” is pointing forward and parallel to the centerline of
the boat. To prevent the sensor from rotating after it is aligned in the bracket,
fasten the 1/2" pan-head set-screw into the most convenient of the two
alternative holes.
Figure 3. Installing the sensor in the mounting bracket
Copyright © 2008, 2009 Airmar Technology Corp.
a
b
sensor
cable
bracket
stud (2)
flat washer (2)
lock washer (2)
thumb nut (2)
brass machine screw (2)
set screw
gasket