Airmar H2183 Owner's Manual & Installation Instructions - page 6
6
Cables & Converting/Connecting Hardware
The Heading Sensor can be connected in several ways. You must have the correct
cable(s) and any needed junction box before beginning the installation.
Cables
NOTE: Additional cable lengths are available.
• NMEA 0183 Cable
10m
Part No. 33-
862-02
• NMEA 2000® Cable
6m
Part No. 33-1029-02
• NMEA 2000® Cable
10m
Part No. 33-1029-06
Converting/Connecting Hardware
• NMEA 0183 to USB Converter
Part No. 33-
801-01
• NMEA 0183 Combiner
Part No. 33-
800-01
• NMEA 2000® CAN to USB Gateway
• NMEA 0183 & NMEA 2000® Splitter
15m
• NMEA 0183 & NMEA 2000® Splitter
30m
Tools & Materials
Safety goggles
Dust mask
Torpedo level
Pencil
Electric drill
Drill bits and hole saws:
Pilot hole
3mm or 1/8"
Bracket screw holes
4mm, #23, or 9/64"
Flush mount stud holes
6mm or 1/4"
Flush mount cable hole
38mm or 1-1/2"
Phillips screwdrivers
Marine sealant (aluminum hull)
Loctite® 242® or other removable thread locker (Flush Mount installation)
Deck gland (some installations)
Grommets (some installations)
Cutting pliers (some installations)
Heat-shrink tubing (some installations)
Wire strippers (some installations)
Multimeter (some installations)
Cable ties (some installations)
Where to Purchase Parts
Obtain parts from your instrument manufacturer or marine dealer. Lost, broken, or
worn parts should be replaced immediately.
Gemeco
Tel: 843.210.7000
(USA)
Fax: 843.210.7170
Email: sales@gemeco.com
Airmar EMEA
Tel: +33.(0)2.23.52.06.48
(Europe, Middle East, Africa)
Fax: +33.(0)2.23.52.06.49
Email: sales@airmar-emea.com