AirRaid Audio Elements Splitter Operation Manual - page 3
of
5
Elements: Splitter
Contents
Loading and saving patches
Loading and saving patches in Splitter is done in the same way as with any other Reason
device. See “Loading patches” and “Saving patches” in the Reason Operation Manual for
further information.
Controls and displays
X-OVERS
X-Over — Sets the crossover frequency between the Low and Mid or Mid and High audio
bands. The frequency value is displayed on the readout above the knob.
24dB — Toggles the crossover slope between 12dB and 24dB modes. 12dB mode
produces a gentler split, whereas as 24dB is significantly steeper.
Welcome!
1
Loading and saving patches
2
Controls and displays
2
X-Overs
2
Bands
3
Rear Panel
3
Page of
2
4