AirRaid Audio Elements Splitter Operation Manual - page 4
Elements: Splitter
BANDS
On — Toggles the band on or off. This only applies to the Low and High bands, as the Mid
band is always active. If either the High or Low bands are turned off, then Splitter functions as
a dual-band effect. If they are both switched off, it acts as a single-band effect.
M (Mute) — Renders the band in question entirely silent.
S (Solo) — Renders both other bands silent, unless they also have their Solo button turned
on. This allows you to quickly audition the output of soloed bands.
M/S (Mid/Side) — Controls the mix between the mono (mid) and stereo (side) components
of the incoming audio signal. When turned fully counterclockwise, to the left, only the mono
signal is heard. When turned fully clockwise, to the right, only the stereo signal is heard.
When turned to the centre position, the signal remains unaffected.
Pan — Pans the band’s output left or right.
Vol — Controls the volume level of the band’s output, allowing you to either attenuate it or
boost it by up to 6 decibels.
REAR PANEL
Modulation In — CV modulation in Splitter works the same way as for any stock Reason
device. The parameters that can be modulated via CV are:
Page of
3
4