AirSep Focus Portable Manual - page 15
MN170-1 rev A 03/11
11
3) Connecting Focus with the Battery, as shown:
Before using the battery, check that it has a sufficient charge.
The battery is equipped with a gauge (Figure 9) to indicate the level of battery charge (25-100%). To check the level of
charge of the battery, press the button on the battery’s keypad. The battery gauge/indicator(s) LEDs to the left of the
button illuminate to indicate the level of battery charge (25-100%).
Connect the switch end of the battery cord into the Focus unit’s power inlet only, as shown in Figures 5 and 6.
Connect the other end into the battery. Do not force the cords, as they can be properly inserted only one way.
Refer to the instructions on charging the battery in the Battery Charging section.
Focus is very light weight and easy to wear using the AirSep-supplied shoulder strap (Figure 4), or belt (Figure 3). You may clip
the battery on to either the strap or belt.
Focus can be worn on the waist by feeding the AirSep-supplied waist belt (Figure 10) or the optional AirBelt, (Figure 11)
through the loops on the back of the Focus unit’s carrying bag. Focus can also be worn over the shoulder with the use of the
AirSep-supplied shoulder strap as shown (Figure 12).
Figure 10: Focus unit worn on the waist Figure 11: Focus unit worn with AirBelt Figure 12: Focus unit worn with the shoulder strap
Focus units Power Inlet
Battery Gauge
Belt / Shoulder Figure: 9
Strap clip