Anritsu 701012 User Manual - page 66
Manual is about: Anritsu USB Power Sensor User Guide
of
70
Upgrading the Firmware
Upgrading the Firmware
D-4
MA24106A UG
7. Click Program Device. The following messages will be displayed during the program operation:
MESSAGE - Programming FLASH Completed
MESSAGE - Erasing and Programming FLASH...
8. Disconnect and reconnect the USB cable from the power sensor, and then click OK to complete the
firmware upgrade procedure.
9. Launch the Anritsu Power Meter application to begin using the upgraded sensor.
Figure D-6.
Firmware Upgrade Application
Figure D-7.