Antari HZ-500 User Manual - page 3
▪Never drink haze liquid. If it is ingested, call a doctor immediately. If hazer
liquid comes in contact with skin or eyes, rinse thoroughly with water.
Pay attention to all warning labels and instructions printed on the exterior
of your Antari Hazer
Open the shipping carton and verify that all equipment necessary to operate
the system has arrived intact. Before beginning initial setup of your ANTARI
HZ-500 Hazer, make sure that there is no evident damage caused by
transportation. In the event of that the unit's housing or cable is damaged, do
not plug it in and do not use it until contacting your Antari dealer for
assistance.
1.Place the unit on a flat surface. Plug power cord into a grounded electrical
outlet.
2.Remove the fluid tank cap and pour the Antari Haze Liquid into the tank
slowly and carefully to avoid overfilling. (Filling Suggestion: Please add 2
litres haze liquid in the first time of refill.Since second refill, add 1 litre
haze liquid for every refill.) Make sure the liquid level does not does not
exceed the mark on the tank.
3.Please refill haze liquid slowly. Otherwise, the haze liquid may overfill and
damage machine.Basically, every refill process of 1-litre haze liquid must
be separated into 5 times. It means after refilling about 200c.c. haze liquid
you have to stop refilling and check the tank. Please make sure that the last
200c.c haze liquids go through the filter inside the tank properly before
pouring next 200c.c. haze liquids into the tank.
(Usually it takes about 10 senconds for 200c.c. haze liquid to go through
the filter)
4.Please use only dealer-recommended high-quality haze liquid . Any other
types of fluids may cause health hazard and damage the unit. Use of any
other liquids may void warranty.
5.Please open the square door on the top of the flightcase before operation in
order to let the haze come out smoothly.
6.Set the power switch to “ON” on the control panel of the machine. Make
sure that the red indicator light is on.
7.There is an intake hole in the back of the flightcase. There are a metal net
and a filter attached on the intake, which can avoid the unit from clogging
problem. Please inspect and clean the metal net and filter periodically.
1.Always monitor and make sure that there is sufficient haze liquid inside the
tank during operation.
2.When the machine is operated for a longer period of time under open-air
conditions, falling dust/debris might attach to the metal net and filter on the
intake hole. The metal net and filter is serviceable, which means those can
be detached easily by screw driver. Please use water to clean the metal net
and filter periodically. By doing this can avoid dust going into the hazers
-Unpacking & Inspection
-Operation & Filling Haze Liquid
-Caution
02 English