Antelope 10M Owner's Manual - page 5
1.
3.
4.
5.
Power Switch
AC Power Supply Indicator
DC Power Supply Indicator
Information Display
Warm-Up Indicator
When depressed, the device is on, which is signaled by indicators
and/or
and the
Information Display
.
When on, indicates the device is connected to a 12 V DC power supply source.
During the warm-up period (just after the device has been switched on) displays the
following message: "Please wait, the rubidium generator is warming up". The device is
operable in this state, but the clock frequency has not yet reached its specified ultimate
stabilit.
Once the device is fully warmed up, the message is replaced by "10M" which means
maximum stability has now been achieved (the clock frequency stability meets
specifications) and the device is ready for use.
When the device is first powered, these LEDs pulsate during the device's warm-up period
as the Rubidium oscillator is heating up. When the device is fully warmed up, the LEDs
glow with steady red light.
When on, indicates the device is connected to a 90-240 V AC power supply source.
2.
1
2
4
3
5
Front Panel
3
4
2
4