Audio Technica ATH-ANC700BT User Manual - Charging The Battery
6
Charging the battery
• Fully charge the battery when using it for the first time.
• When the rechargeable battery is running low, the product will sound 2 sets of 2 beeps through the headphones, and
the multi-indicator lamp will flash in red. When these beeps sound, charge the battery.
• It takes about 5 hours to charge the battery fully (this time may vary depending on usage conditions).
• While the battery is charging, the product’s Bluetooth connection remains disabled and therefore the product’s
Bluetooth function cannot be used.
1. Connect the included USB charging cable (micro USB Type-B side) to the product’s battery jack.
• The included USB charging cable is designed for exclusive use with the product. Do not use any other USB
charging cable.
• When inserting the USB charging cable into the USB port or battery jack, check that the terminal is facing in the
correct direction before inserting it directly (horizontally).
2. Connect the included USB charging cable (USB Type-A side) to the computer to start charging.
• While charging, the multi-indicator lamp lights as follows (it may take several seconds for the multi-indicator lamp
to light).
Lit in red: Charging
Unlit: Charging complete
3. When charging is complete, disconnect the USB charging cable (USB Type-A side) from the computer.
4. Disconnect the USB charging cable (Micro USB Type-B side) from the product’s battery jack.
• If you charge the product with its power on, it will turn off while the product is charging. When charging is
complete and the USB charging cable (USB Type-A side) is disconnected from the computer, the product turns on
again.
Battery jack
USB port
USB Type-A
USB charging cable
(included)
Micro USB Type-B
Computer