B&K AV100.2 User Manual - page 10
10
Input and Output Connections through RJ-45
The AV Brick Amplifiers have RJ-45 inputs that are designed to connect mul-
tiple AV amplifiers. A straight through CAT-5 cable is needed to send signal
and a optional control output from one AV amplifier to another. When using
the RJ-45 input from one to another, signal is always sent. If a trigger is to be
sent from one brick amplifier to another when using the RJ-45 connection, set
the RJ-45 I/O switch AND the CTRL IN to the ON position on BOTH amplifi-
ers as shown. Shown below is a total of three Brick Amplifiers connected with
the RJ-45 connection. The source comes into the first amplifier and the same
signal is sent to the other amplifiers from the output of the first amplifier to the
input of the second and so forth.
From Preamplifier
AV Amplifier
AV Amplifier
AV Amplifier
Note: Up to eight separate AV Brick Amplifiers can be connected by the RJ-45 Input and Output
connections. The max length of total CAT-5 cable can be up to 300 feet from the RJ-45 output of
the first AV amplifier to the RJ-45 input on the last AV amplifier.
RJ-45 Input/Output Drive Pinout
It is suggested to ONLY use the RJ-
45 Inputs and Outputs to connect
multiple AV Brick Amplifiers.
CAT-5 RJ-45 pinouts use the T568B
standard.