B&K AV100.2 User Manual - page 5
5
Front and Back Panel Explanation
1. Model—Label of the model of amplifier. Lists the watts per channel of
the amplifier.
2. AC Input Receptacle - For attaching the supplied AC power cord to the
amplifier.
3. Power Switch - Power switch for hard powering the amplifier.
4. Speaker Outputs - For connecting the speakers to the amplifier. Ex-
plained further under Output Connections.
5. Status LED - Two LED’s that show power and amplifier state. Ex-
plained further under Status LED.
6. Amplifier Control Input/Output - Provides remote switching of the
amplifier's standby on/off feature. Explained further under Control Trig-
gers.
7. Dip Switch Setup - The amplifier uses DIP switches to configure the
RJ-45 Input / Output, mono and muting control. Further explained under
DIP Switches.
8. Volume/Level Control - The volume control is located on the back
panel as a dual potentiometer. The outer (larger) level control adjusts signal
for the right channel. The inner (smaller) level control adjusts the signal for
the left channel.
9. RJ-45 Input / Output - Input and output for connecting multiple AV
Brick amplifiers. Further explained under Input and Output Connections
Through RJ-45.
10. RCA Input - For connecting RCA interconnects from the preamplifier
to the amplifier. Explained further under Input Connections Through RCA.