B2 Audio M1 Owner's Manual - page 3
1. Design features
Circuit Configuration
Frequency Response
Signal to Noise Ratio
Input Sensitivity
Input Level Selector
Crossover
High Pass Filter
High Pass Multiplier
Low Pass Crossover Range
Low Pass Multiplier
Subsonic Crossover Range
Bass Boost
Phase
Output Master / Input Slave :
Remote Control
Damping Factor
Power Terminal gauge
Fuse Rating
HI-EF Class D Mono
: 20Hz ~ 250Hz
: 100dB
: 6V ~ 0.2V
: -
: 24dB / Oct
: -
: -
: 35Hz ~ 250Hz
: -
: 10Hz ~ 50Hz
: 0 ~ 9dB
: 0 ~ 180
:
: 350<
: 0 ga x 2
: 750A
(Linked: 1500A)
All features are subject to change in the continuing effort to improve the products without notice.
2600 W x 1 4800 W x 1
8500 W x 1
3300 W x 1 5800 W x 1 9100 W x 1
4000 W x 1 6900 W x 1 9500 W x 1
Specifications (detailed)
2) The amplifier
is designed with a 4 stage advanced protection circuit;
Thermal protection, Voltage sensors, DC offset & short circuitry via speaker outputs
.
The double sided pcb features high current mosfet switching devices in both the in- and output stage.
5) A wired remote level control is included for the
.
- This unit will enable remote gain adjustment.
- For more advanced features like selectable bass frequency, boost level & gain,
This will produce twice the power of one single unit
@ 1 .
Specifications
Continious output power rating (RMS) - Measured @ 14.4 V, 16 V & 18 V
1)
4)
3
3)
M1
M1
Power @ 4
Power @ 2 Power @ 1
The amplifier,operates stable @ impedances of minimum 1 .
A daisy chain (linked) configuration will require a minimum 2 .
The crossover of the M1 is a 24 dB/octave filter.
- which features low pass & subsonic options for the amplifier.
the
Better Bass Remote
(optional) can be used.
6) A Daisy chain configuration of the amplifier will allow strapping of 2
amplifiers @ a 2 load.