B2 Audio M1 Owner's Manual - page 6
+12V, GND, REM CONNECTION DIAGRAM
CAUTION
The minimum impedance is 1 ohm as a single unit.
In linked mode the minimum impedance is 2 ohm.
Keep speaker cables away from power cables and the amplifier’s RCA input cables.
Use grommets anywhere the cables have to penetrate the vehicle’s chassis.
Connect the speakers according to terminals on each speaker.
Strip 3/8" of insulation from the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals which may cause a short.
8 ohm
~ 1ohms
FUSE
Ground
Remote turn on
Main Battery
12V
Headunit
750A
We recommend to use 12 gauge speaker cables for increased performance.
Run 12 AWG speaker connecting cables from your speakers to the amplifier's mounting location.
Crimp spade plugs over the cable ends or tin the ends with solder to provide a secure hold.
Connect the cable ends to the amplifier as shown on the speaker system diagram.
SPEAKER CONNECTION DIAGRAM
6
3.2 POWER / SPEAKER CONNECTIONS