Summary of Zero 1
Page 1
Model: zero1 product id:zero116d owner’s manual zero1.
Page 2
Introduction we thank you for purchasing our amplifiers. Your decision to be part of something different is what we strive for. Our products reflects who we are, going to the extent to deliver you our finest comes natural. To upgrade the stock electrical system. Ensure the system is in accordance with t...
Page 3
Bass boost: 0 ~ 9 db phase: 0 ~ 180° design features circuit configuration: hi-ef class d frequency response: 15 hz ~ 250 hz signal to noise ratio: > 100 db input sensitivity: 6 v ~ 0.2 v crossover circuit: 24 db / octave low pass crossover: 35 hz ~ 250 hz subsonic crossover: 10 ~50 hz damping facto...
Page 4
Bass boost: 0 ~ 9 db phase: 0 ~ 180° design features circuit configuration: hi-ef class d frequency response: 15 hz ~ 250 hz signal to noise ratio: > 100 db input sensitivity: 6 v ~ 0.2 v crossover circuit: 24 db / octave low pass crossover: 35 hz ~ 250 hz subsonic crossover: 10 ~50 hz damping facto...
Page 5
5 zero1 gnd (ground connection) + 12v (power connection) connects to the vehicle’s chassis. Connects to the positive terminal of the battery. Keep as short as possible ( for specified performance 0 ga cable is required. Use minimum 0 ga cable for optimal conditions. Fuses shall be placed within 8” /...
Page 6
Installation installation considerations if you choose to install the amplifier by yourself, please read the entire owner’s manual carefully. Before you start your installation, please take all steps into consideration. If in doubt, please go to www.B2audio.Com for authorized distributors / dealers ...
Page 7
5 zero1 head unit caution installation of the amplifier shall be done in the following steps: 1. Connect the +12v wire, keep in mind this wire has to be fused at the battery as well. 2. Ensure the ground is appropriate, then connect it to the amplifier. 3. Connect the switched remote. 4. Reattach ne...
Page 8
Zero1 speaker impedance 1~8 ohms speaker wiring diagram - single amplifier speaker impedance 1 ohm ~ 8 ohm loads under what is specified will cause excessive heat & the amplifier will reach thermal at a faster rate & will eventually go into protect. Impedance load under 1 ohm is not warranted! Strap...
Page 9
Zero1 strapped speaker wiring master / slave 9 to link the master and slave amplifier speaker connection follow the steps below. Step 1. Run the positive (+) speaker cable from the master amplifier’s speaker output to the positive terminal (+) of the subwoofer. Step 2. Run the positive (+) speaker c...
Page 10
10 strapped control panel setting master / slave 1 to link the master and slave 1 amplifier rca connection follow the steps below. Keep in mind amplifiers needs to be switched off, linking the amplifiers when switched on may cause harm and can void your warranty! Step 1. Connect rca from head unit /...
Page 11
11 control panel setting master / slave 2 / slave 2 slave 2 master l head unit slave 2 to link the master and slave 2 amplifiers in daisy chain mode follow the steps below. Each slave 2 will be controlled by the master’s control panel, but the speakers must be connected individually to each amp. The...
Page 12
. Feel free to visit us at: www.B2audio.Com / www.Facebook.Com/b2audio / twitter:@b2_audio / instagram: b2_audio / www.Youtube.Com/b2audio 13 the protection circuits of the amplifier prevents severe damages from faulty conditions & improper use. The protection indicatior will switch on due to short ...