B2 Audio Zero 1 Owner's Manual - page 11
11
Control panel setting Master / slave 2 / SLave 2
slave 2
master
L
Head unit
slave 2
To link the master and slave 2 amplifiers in daisy chain mode follow the steps below. Each slave 2 will be controlled by the master’s control panel, but
the speakers must be connected individually to each amp. The daisy chain is a true benefit when you have multiple speakers and amps.
Step 1. Connect RCA from Head Unit / output source into
master amplifier RCA input.
If only one output is available, then use a Y-split to connect both L & R.
Step 2.
Locate the Master / Slave 1 / Slave 2 switch on the right side of the control panel on the
Master amplifier. Set the switch to
Master.
step 3. Connect a single RCA from the RCA OUT
on the
master
amplifier.
Step 4. Locate the Master / Slave 1 / Slave 2 switch on the right side of the control panel on the first
Slave 2
amplifier. Set the switch to
Slave 2.
Step 5. Connect the single RCA cable from the Master
amplifier’s
Rca out
to the
first
slave 2
amplifier’s single
RCA IN.
step 6. Connect a single RCA from the RCA out on the first slave 2 amplifier & connect the other end to the second Slave 2 amplifier’s RCA IN.
step 7. Set the Master / Slave 1 / Slave 2 switch on the right side of the control panel on the second Slave 2 amplifer to slave 2.
step 8. Connect the speaker(s) to each individual amp.