B2 Audio Zero 1 Owner's Manual - page 8
zero1
Speaker Impedance 1~8 ohms
Speaker Wiring Diagram - single amplifier
Speaker impedance 1 Ohm ~ 8 Ohm
Loads under what is specified will cause excessive heat & the amplifier
will reach thermal at a faster rate & will eventually go into protect.
Impedance load under 1 ohm is not warranted!
Strapped control panel setting / speaker wiring
Speaker impedance 2 Ohm ~ 16 Ohm
Loads under what is specified will cause excessive heat & the amplifier
will reach thermal at a faster rate & will eventually go into protect.
Strapped impedance load under 2 ohm is not warranted!
8
BASS
BOOST
0dB 9dB
BASS
FREQ
30Hz 80Hz
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
BASS
BOOST
0dB 9dB
BASS
FREQ
30Hz 80Hz
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
Speaker Impedance 1~8 ohms
Head unit
MASTER AMPLIFIER
SLAVE AMPLIFIER
Speaker Impedance 2~ 8 ohms
BASS
BOOST
0dB 9dB
BASS
FREQ
30Hz 80Hz
MASTER
SLAVE1
SLAVE2
SWEET LIKE DANISH
Linking or strapping makes 2 amplifiers work as a single amplifier. This configuration will near double the rated
output power. Follow the instructions carefully as it can cause harm to your system if done incorrect.
To enable this function, let the master amplifier switch next to the phase knob stay in “OUTPUT MASTER”.
On the slave amplifier, this switch shall be in “INPUT SLAVE”.
Run a RCA cable from the master amplifier’s “RCA OUT”.
Connect the other end of the RCA to the slave amplifier’s “RCA IN” located next to the “INPUT SLAVE” switch