Baby Jogger Britax Companion Instructions Manual - page 3
1
To install the Pram you will need the following adapter part(s):
2 – Adapter Brackets (1 – left, 1 – right)
1. Remove the canopy and seat from stroller frame.
Please refer to the owner manual.
(Be sure to store fabric and hardware for later use.)
2. Secure Right Adapter Bracket to frame directly below the
folding mechanism making sure to align the notches in the
Adapter Bracket over the snap and rivets. (Fig. A)
Repeat to the left side.(Fig. B)
Note:
Do not over tighten. Over tightening will damage
the product and void the warranty.
3. Place Pram onto Adapter Brackets, making sure child will be
facing toward stroller handle. Firmly press down on the Pram
until you hear a click which means it’s locked in place. (Fig. C)
Note:
The Red compression locks and the support bars are
not applicable when using the Baby Jogger Pram
4. To remove Pram from the Adapter Brackets, press the two
buttons on the Pram handle and lift up carefully.
5. To retract canopy, push button on canopy hinge and push
canopy back out of the way. To use canopy in the extended
position, push button and pull canopy forward.
Note:
To avoid safety belt strap catching on wheels, secure them
to each other in order to avoid hanging.
Pram
(Fig. A)
(Fig. B)
(Fig. C)