Baby Jogger Britax Companion Instructions Manual - page 6
4
Graco/Evenflo Car Seat
To install a Graco/ Evenflo car seat you will need the following
adapter part(s):
2 – Adapter Brackets (1 – left, 1 – right)
1 – U-Shaped Support Bar
1. Remove the canopy and seat from stroller frame. Please refer to the
owner manual. (Be sure to store fabric and hardware for later use.)
2. Secure Right Adapter Bracket to frame directly below the folding
mechanism making sure to align the notches in the Adapter
Bracket over the snap and rivets. (Fig. A)
Repeat to the left side. (Fig. B)
Note:
Do not over tighten. Over tightening will damage the product
and void the warranty.
3. Open the compression locks by flipping the Red Latches up
to allow U-Shape Support Bar to be inserted into Adapter
Brackets. (Fig. C)
4. Insert the U-Shaped Support Bar with the curved end pointing up
into the Adapter Brackets. (Fig. D)
5. Place car seat onto U-Shaped Support Bar. Adjust U-Shape
Support Bar to proper length by sliding frame in and out. Use car
seat to insure proper distance. Close compression locks by flipping
the red latches down. (Fig. E)
6. Secure the car seat to stroller using Safety Belt. (Fig. F)
Note:
The Straight and Spring Support Bars are not applicable when
using a Graco or Evenflo car seat.