Baby Jogger Britax Companion Instructions Manual - page 8
6
Britax Companion Car Seat
To install the Britax Companion car seat you will need the
following adapter part(s):
2 – Adapter Brackets (1 – left, 1 – right)
1 – U-Shaped Support Bar
1 – T-Shaped Support Bar
1. Remove the canopy and seat from stroller frame. Please refer to the
owner manual. (Be sure to store fabric and hardware for later use.)
2. Secure Right Adapter Bracket to frame directly below the
folding mechanism making sure to align the notches in the
Adapter Bracket over the snap and rivets. (Fig. A)
Repeat to the left side. (Fig. B)
Note:
Do not over tighten. Over tightening will damage the product
and void the warranty.
3. Open compression locks by flipping the red latches up. (Fig. B)
4. Insert the U-Shaped Support Bar with the curved end pointing up
into Adapter Brackets. (Fig. D)
5. Place car seat onto U-Shaped Support Bar. Adjust U-Shape
Support Bar to proper length by sliding frame in and out.
Use car seat to insure proper distance. Close compression locks
by flipping the red latches down. (Fig. E)
6. Place the T-Bar onto car seat as shown and tighten strap using
D-Ring and Velcro. (Fig. F)
7. Secure the car seat to stroller using Safety Belt.
Note:
The Straight Support Bar is not applicable when using the
Britax Companion car seat.