Baby Jogger CITY ELITE SINGLE Assembly Instructions Manual - page 6
9
8
Raised Kicker
Basket
1
To use the raised kicker, pull
up on seat flap above the
footplate, and remove the
kicker stand from storage
pocket. Attach the kicker
stand to the seat with the
hooks provided under seat flap.
1
From the front of the stroller: Remove lower
seat fabric to expose bottom front portion
of frame. Fasten basket Velcro around frame
tubing on right side. Repeat on left side.
Re-apply seat fabric to frame once complete.
2
Attach kicker stand by
wrapping both sides of the
webbing under the footplate.
Thread one side of the velcro
webbing through the D ring
of the other side, and secure
velcro together.
2
From the rear of the
stroller: Fasten the top
snaps of the basket
around frame tubing
above the middle
support bar.
3
When not using the raised
kicker, tuck the kick stand
and the webbing straps into
the pocket provided under
the seat.
3
Fasten the bottom
snaps of the basket
around frame tubing
below the middle
support bar.
1
To recline: Pinch the clamp behind the seat, and slide it down to desired recline. Pull seat down on
both sides to match recline position of clamp.
Reverse steps to return to the upright position.
Reclining Seat
• Weather Cover: If desired, pull weather cover down
and over the seat back mesh. Secure firmly over
both sides of seat. When not in use, roll weather
cover up and fasten with elastic loop and barrel
provided under top of the seat fabric.