Baby Lock Audrey BL67 Manual - Winding The Bobbin
Winding the Bobbin
reMOVinG THe BOBBin
1
Remove the bobbin cover by sliding the release lever to the right and push down the left corner of
bobbin cover at the same time.
2. Remove the bobbin from the machine.
1. Raise the presser foot lever. Pivot spool pin into highest position. Place a spool of thread on the spool
pin. Secure it with the spool cap to ensure smooth flow of thread. Use a spool cap closest in size to
the spool of thread being used.
2. Pass thread from the spool through the thread guides as shown.
3. Pull the end of thread through hole in bobbin as shown.
4. Move bobbin winder shaft to the left. Place bobbin onto shaft until it clicks into position with the end
of thread coming from top of bobbin. Push bobbin winder shaft to the right until it clicks. Hold onto the
end of thread.
5. Start machine to wind the bobbin. Stop machine after a few turns to trim the thread tail with scissors.
Bobbin will stop turning when completely filled. Cut the thread and push shaft to the left to remove
bobbin.
2
1
WINDING THE BOBBIN
4
5
3
2
1
WinDinG THe BOBBin
1