Baby Lock Pro-Stitcher BLPS Instruction And Reference Manual - Y-Rack Installation

 Page 6

Figure 5

Y-Rack Installation

1.

 Carefully lay the quilting machine on its side 

(Figure 6).  Underneath the base plates, near the 

wheels on the side of the machine facing up (the 

side with the thread tensioner and guides) there will 

be either two screws or two holes.  If the screws are 

there, use a large slotted (fl at) screwdriver to remove 

the screws (Figure 5).

2.

 Attach the Y-Rack as shown in Figure 6.  The blue 

fl exirack should be toward the middle of the machine 

while the bolt holes should be toward the outside.  

Use the screws that were removed from the front and 

rear base plates (or use the two smallest screws in 

the Base Plate Repair Kit (Page 3, D) if your machine 

had no screws here) to mount the Y-Rack to the bot-

tom of the front and rear base plates.  Be careful not 

to over-tighten the screws as the base plate holes will 

strip easily.  In case of accidentally cross-threading or 

stripping one of the base plate holes, an emergency 

repair kit (Page 3, D) has been provided.

3.

 If the screws in the base plates do not have slot-

ted heads and a nut driver cannot be fi tted over the 

screw head, please use one of the provided slotted 

screws as a replacement (Page 3, D) and use a slotted 

screwdriver to tighten the screws in place.

Figure 6

Y-Rack

Y-Encoder