Baby Lock Pro-Stitcher BLPS Instruction And Reference Manual - Setting Up The New Carriage

 Page 7

Y-Encoder

Figure 7

Setting up the New Carriage

1.

 With the Pro-Stitcher carriage set properly on 

the frame system, untie the black twist ties that are 

binding the black cables in a loop.  Drape the black 

cables over the back of the carriage as shown in 

Figure 7.

2.

 Plug one branch of the new “Y” power cord 

(Page 3, I) into the power supply located toward the 

rear of the carriage (Figure 8).  Route the power cord 

as shown in Figure 7.  It is also permissible to have 

the power cord extend directly out the side of the 

carriage rather than over the top of the carriage.

3.

 With the X-axis engagement lever shifted into the 

lowest position, verify that the white gear at the front 

of the carriage fully engages with the blue fl exirack 

that was previously installed.

a. If the white gear fails to lower enough with the 

front disengagement lever in its lowest position, you 

will need to adjust the black X-axis lever bracket to 

allow the X-axis engagement lever to drop a little 

lower.  To do this, loosen the two 4mm Allen bolts 

and pivot the bracket downward until the white gear 

is pressing fi rmly on the blue fl exirack, then re-tight-

en the two bolts (Figure 9).

Figure 8

Figure 9

Adjust only

if necessary

Plug

“Y” power cord

Back of Carriage