Baby Trend JG95 Instruction Manual - Assembly
5
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
6
ASSEMBLY
ASSEMBLY
3)
• Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
4)
• With the wheel in position, tighten the
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 4).
REAR WHEELS
5)
• Rest the stroller upside down, on the handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
6)
• Tires are shipped un-inflated. The tires
should be inflated on a regular basis to
between 20 to 25 p.s.i. Always use a
bicycle style hand air pump to inflate the
tires (Fig. 6). *not included.
CUP HOLDER
WARNING:
To avoid
burns, never put hot liquids
in cup holder. Avoid possible
tipping, do not place more than
1 lb. (0.45kg) in cup holder.
7)
•
To attach cup holder: slide the clip
on the cupholder over Cup Holder tabs
on the Handle Bar. Push untill firmly in
place (Fig. 7).
CANOPY
8)
•
To open the canopy: push forward on
the front edge of the canopy while holding
the rear of canopy in place (Fig. 8).
•
To fold the canopy: pull backwards on
the front edge (Fig. 8).
SEATBACK POSITIONING
9)
•
To recline the seat: loosen the strap
through the buckle and adjust to the
required recline position (Fig. 9a). To
place the seat back in a more upright
position, press upward on the seat back
with one hand while pulling the strap
through the buckle with the other (Fig. 9b).
Note: The upright position should be
used
only for a child that is at least 6
months old. Always re-adjust the safety
harness, including the shoulder belts,
when repositioning the seatback.
Fig. 3
Retainer Plate
Axel Nut
Axel and Hub
Front Fork
Slot
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9b
Fig. 9a
Fig. 4