Baby Trend JG95 Instruction Manual - Fold / Unfold
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
12
FOLD / UNFOLD
11
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
TO FOLD STROLLER
CAUTION:
Do not allow
children near stroller while
folding.
20)
• Close the canopy as described in the
canopy section. Recline seat by releasing
buckle as described in seatback
positioning section.
• The stroller is folded by simultaneously
pulling each trigger (Fig. 20a). When the
fold latches are released, the handle will
begin to fall toward the floor. Release
the trigger and press downward on
the stroller handle until the stroller is
completely folded. Secure the stroller
in the folded position by locking the fold
latch, located on the right side of the
stroller, over the rivet that protrudes from
the frame (Fig. 20b).
TO UNFOLD STROLLER
CAUTION:
Do not allow
children near stroller
while unfolding.
21)
• Release the folding latch, which is
located on the right side (Fig. 21a).
• Lift up on the stroller handle with both
hands until the stroller frame is locked in
the open position (Fig. 21b). The stroller
has spring-loaded latches on both sides of
the frame. Test that both latches are fully
engaged prior to placing child in the stroller.
INFANT CAR SEAT ATTACHMENT
WARNING:
Never jog
or run with your newborn in
the car seat position. Use for
strolling only.
WARNING:
Avoid
serious injury from falling
or sliding out, always use
the Infant Car Seat harness.
18)
• Fully recline seat back and turn car seat
Support Tabs on the stroller frame (Fig 18a).
Note: Car Seat Support Tabs are Only
used for the infant car seat. Check that
the front child tray is firmly attached to
the stroller armrests.
• Position the infant car seat so that it
faces toward the rear of the stroller and
the seat shell goes into the front tray and
latches into place (Fig. 18b).
• When the infant car seat is locked firmly
into place,
strap the single Short Clip
over the infant car seat
through the seat
belt slot on the infant car seat (Fig. 18c).
Note: It is very important that the Short
Clip is always tightly fastened around the
infant car seat.
TO REMOVE INFANT CAR SEAT
19)
• To remove the Infant Car Seat,
disengage Short Clip and squeeze the
release handle located at the foot-end of
the seat and carefully lift upward on the
seat (Fig. 19).
Fig. 18a
Fig. 18b
Fig. 18c
Short clip
Fig. 19
Fig. 20b
Fig. 20a
Fig. 21a
Fig. 21b