BaByliss 2990U User Manual - page 4
• Do not immerse the appliance in water or other
liquids.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged or if the
appliance has been dropped. In the event of damage
contact the Conair Customer Care Line (refer to ‘UK
After Sales Service’ section for further information).
• Do not use the appliance if the lead is damaged. In
the event of damage contact the Conair Customer
Care Line (refer to ‘UK After Sales Service’ section
for further information).
• Do not leave the appliance unattended when switched
on or plugged in.
• This unit is equipped with a safety thermostat. In the
event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the airstyler to the “0” position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear filter is clear of hair and other debris.
Plug in and switch on. If the appliance continues to
overheat discontinue use immediately, switch off and
unplug, and contact the Conair Customer Care Line
(refer to ‘UK After Sales Service’ section for further
information).
• Do not place the appliance on any heat sensitive
surface whilst in operation.
• Take care to avoid the hot surface of the appliance
coming into direct contact with the skin, in particular
the ears, eyes, face and neck.
• Always ensure that the rear air filter is kept away from
hair during use to prevent it being dragged into the