BaByliss 2990U User Manual - Interchangeable Brush Heads

Interchangeable Brush Heads

•  To attach a brush head, place it over the body of the unit and slide it 

down into position.  

•  Lock the brush head in place by sliding the switch on the top of the 

brush to the locked position.

•  To remove a brush head, ensure the switch on the top of the brush 

head is in the open position.

•  Gently slide the brush head up and off the unit to remove.

Volume, Body & shape

1)  Start  by  sectioning  the  hair  and  combing  through  to  remove  any 

tangles.

2)  To turn the appliance on, slide the ‘on/off’ switch to the correct heat 

setting for your hair.

3)  Place the brush underneath the hair section close to the roots and 

brush through the section to remove any tangles.

4)  For  added  root  lift,  hold  the  brush  in  place  at  the  root  for  a  few 

seconds.

5)  Starting at the root, move the brush through the hair section.  Towards 

the end of the hair section start to rotate the brush away from your 

head by pressing and holding the appropriate rotation button, this 

will create shape and movement through the lengths of the hair.

6)  As you do this, resist the rotation of the brush by pulling the brush 

downwards. This will create tension through the section of hair. 

IMPORtANt! It may take several attempts to perfect this technique, 

if the brush spins too quickly, simply release the rotation button and 

remove from the hair.

7)  For maximum volume, place the brush at the end of the hair section 

and allow the brush to rotate up the hair section by pressing and 

holding the appropriate rotate button.  Wind the entire section of hair 

around the barrel until you reach the root.  Release the rotate button 

and then hold the brush in the hair for a few seconds.

8)  Slide the switch to the cool setting ‘*’ for a further few seconds, this 

cools the hair to create longer lasting volume.