BabyLove EZY GROW EP Instruction Book - page 13
24
HOW TO SETUP
HOW TO SETUP
25
Engage into
Seat belt
buckle
Near seat belt slot
Seat belt feeds through
slot in seat between
trim and seat back.
FORWARD-FACING SEATBELT PATH
(marked in yellow)
INSTALLING INTO VEHICLE (FORWARD-FACING) (UPRIGHT OR RECLINED)
A. Determine whether an upright or reclined
installation is required.
B. To move the Recline Foot from upright to reclined
mode or vice versa. Pull the Foot outwards to
unlock it, then rotate the foot.
Push inwards to lock in place. See diagrams below.
Pull out
Rotate
Push in
to lock
UPRIGHT
RECLINED
NOTE: Some vehicle seats have more rearward slope
than others. Use a rolled up towel or padding under the
seat for contoured vehicle seats to prevent excessive
recline.
Ensure that the child restraint is not over reclined. The
backrest should not be reclined more then 45°.
Rolled up
towel or
padding
Pull the centre panel flap down and gently lift headrest trim end.
Fully lengthen seatbelt and feed the seatbelt through the closest
seatbelt path slot and pass across the seating surface through the
opposite slot. Follow the yellow belt path label -
FORWARD-
FACING BELT PATH
and engage the seatbelt into the buckle.
Put the top tether strap over the back of the seat to avoid it becoming
trapped during seat fitment.
C. Position restraint centrally to the chosen car seat position. The restraint must be in a forward facing
direction. Some vehicle seat fabrics (particularly velours) may be damaged by a child restraint used
continuously. We recommend the use of a thick towel or other protection under and behind the seat to
keep the vehicle seat in good condition.
Car's
seatbelt
Headrest trim end
Centre
panel flap