BabyLove EZY GROW EP Instruction Book - page 14
26
27
HOW TO SETUP
HOW TO SETUP
E. Push down on the restraint to compress it into
the vehicle seat. Whilst compressed in the seat,
pull on the lap portion to remove all slack from
the belt. Pull the sash belt and allow excess
belt to feed back into the retractor. Ensure all
slack is removed from the lap and sash belt.
F. Then engage the buckle and tighten the
seatbelt so the restraint is held firmly
against the car's back.
G. Pull the top tether adjustment strap (C) to remove any
slack but do not tighten. Roll up excess strap and use
pocket at the top of the cover to store the excess strap.
EXPLANATION NOTE:
This method of installation
ensures good seatbelt tension, even with the child in
the seat. We recommend that as your child grows, you
should periodically check the seatbelt and top tether
tension to ensure that (a) the car seatbelt has not
slackened off and (b) that the restraint is not "hanging" on
the top tether strap.
IMPORTANT :
Roll up excess strap
and store in the
pocket attached to the
top of the cover.
Pull Adjustment
Strap to remove
slack
C
B
A
Always ensure that the car seatbelt and top tether strap are firmly restraining the restraint on the vehicle
seat.
Always secure the loose end of the top tether strap to prevent it hanging out of the car or being accessible
by the child.
Make sure cup holders (if fitted) do not interfere with closure of the car door.
Always attach top tether hook and remove slack in the top tether strap.
Always secure the loose end of the top tether strap to prevent it hanging out of the car or being accessible
by the child.
Always attach hook and remove slack.
Remove all
slack from
lap portion,
then sash.
A
B
Attachment Clip
Car's Anchor Fitting
D. Lengthen the top tether strap and connect the
attachment clip to the car's upper anchorage point in the
car making sure to remove as many twists as possible.
To lengthen the top tether strap, fully press adjuster
button (A) while pulling top tether strap (B) to slacken
as shown right.
Refer to your vehicle owner’s manual for the location of
the upper anchorage point in the car. If the vehicle is not
fitted with a child restraint upper anchorage point then
refer to page 36 to 38 for the installation of the upper
anchorage point provided with this child restraint.
Fully press Adjuster Button (A) while
pulling top tether strap (B) to lengthen.
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage seatbelt tongue from buckle and remove
from restraint.
B. Fully press top tether strap adjuster button (A) while
pulling top tether strap (B) to slacken as shown right.
In some vehicles loosening of the top tether strap
may be difficult. If so, try pushing the restraint against
the vehicle seat back or slightly lifting the restraint to
release the tension.
C. Disengage the attachment clip from the car's
upper anchorage point. The child restraint is now
disconnected and can be removed from the car.
Fully press adjuster button (A) while
pulling top tether strap (B) to lengthen.
Roll up excess strap and
store in the pocket attached
to the cover to avoid tripping
when moving the restraint.
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP TETHER STRAP DAMAGED
BY UNSECURED CARGO IN A COLLISION. SECURE OR REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD RESTRAINT.