Bacharach Microprocessor Module Replacement Kit Instruction Manual

Other manuals for Microprocessor Module Replacement Kit: Instruction Manual, Instruction Manual, Instruction Manual

Manual is about: for Multi-Zone Leak Monitors

Page of 8

Download

Print this page

Bookmark us

3015-5576 Rev 2

621 Hunt Valley Circle

New Kensington, PA 15068

3015-5576

Tel:

724-334-5000

Revision 2

Fax: 724-334-5001

May 2013

Microprocessor Module Replacement Kit

for Portable Area Gas Monitors (PAGMs)

Instruction Manual

1. Scope

The Bacharach PAGM family of portable area gas monitors is designed for easy maintenance and enhancement. One

element of that design is the ability to replace system programming (firmware) with a simple plug-in microprocessor

module, minimizing downtime.

This instruction manual describes how to replace or upgrade the microprocessor module in your PAGM infrared gas leak

detector. It is assumed that the user is familiar with the operation of the device. If necessary, refer to the instructions for

detailed operation and maintenance information for each PAGM model.

2. Items Required

• Replacement Microprocessor Module Kit (P/N: 3015-5579)

• Medium Phillips head screwdriver

• Original PAGM instruction manual (optional)

1 2 3 4 5 6 7 Next › »

Summary of Microprocessor Module Replacement Kit

Page 1
3015-5576 rev 2 1 621 hunt valley circle new kensington, pa 15068 3015-5576 tel: 724-334-5000 revision 2 fax: 724-334-5001 may 2013 microprocessor module replacement kit for portable area gas monitors (pagms) instruction manual 1. Scope the bacharach pagm family of portable area gas monitors is desi...
Page 2
Microprocessor module replacement kit for portable area gas monitors 2 3015-5576 rev 2 warning: failure to comply with these instructions may void the warranty. 3. Procedure summary all system settings and configuration settings are returned to factory default values after this upgrade. You may choo...
Page 3
Microprocessor module replacement kit for portable area gas monitors 3015-5576 rev 2 3 front remove screws (3) rear remove screws (3) right side remove screws (2) figure 1. Disassembling the pagm: screw locations 5. Remove the microprocessor board prepare to remove the old microprocessor module by f...
Page 4
Microprocessor module replacement kit for portable area gas monitors 4 3015-5576 rev 2 2. Locate the red microprocessor module, socketed on the bottom right side of the main circuit board. A cable tie surrounds the main board and the microprocessor module to secure it. Refer to figure 2. Carefully c...
Page 5
Microprocessor module replacement kit for portable area gas monitors 3015-5576 rev 2 5 figure 4. Microprocessor module removed from pagm main board 6. Installing the new microprocessor module install the new microprocessor module by following the steps below. Depending on your hardware and the repla...
Page 6
Microprocessor module replacement kit for portable area gas monitors 6 3015-5576 rev 2 figure 5. Option a installation 7. Re-attach the main board to the enclosure by carefully placing the main board onto the enclosure standoffs and securing it with the screws removed earlier. 8. R eplace the rear p...
Page 7
Microprocessor module replacement kit for portable area gas monitors 3015-5576 rev 2 7 note : as a guide, align the larger hole on the microprocessor module with the top of the snap-in spacer. If aligned properly, the pins will align with the main board socket and the hole in the microprocessor boar...
Page 8
Microprocessor module replacement kit for portable area gas monitors 8 3015-5576 rev 2 headquarters: 621 hunt valley circle, new kensington, pa 15068-7074 toll free: 1-800-736-4666 • tel: +1-724-334-5000 • fax: +1-724-334-5001 website: www.Mybacharach.Com • e-mail: help@mybacharach.Com printed in u....