Bacharach Microprocessor Module Replacement Kit Instruction Manual - page 3
Other manuals for Microprocessor Module Replacement Kit:
Instruction Manual, Instruction Manual, Instruction Manual
Manual is about: for Multi-Zone Leak Monitors
of
8
Microprocessor Module Replacement Kit for Portable Area Gas Monitors
3015-5576 Rev 2
3
Front
Remove
Screws (3)
Rear
Remove
Screws (3)
Right Side
Remove Screws (2)
Figure 1. Disassembling the PAGM: Screw Locations
5. Remove the Microprocessor Board
Prepare to remove the old microprocessor module by following the steps below.
Items Required:
Scissors or wire cutters (to remove a wire tie).
Medium standard slotted screwdriver
Wrench for lock nut
Procedure:
1. Dissipate any accumulated static charge by touching a grounded area of bare metal.
WARNING: Failure to touch a metal grounding area on the product can allow static electricity on
your clothing or body to damage the monitor or modules. Such damage is not covered under
warranty.