Back to Basics FB500 Instruction Manual - page 5

A

SSEMBLING 

Y

OUR 

B

LENDER 

Before assembling your Fitness Blender wash all parts, 

except for motor base,

 in 

warm, soapy water, rinse thoroughly and dry.  Unscrew and disassemble the valve 

for cleaning (see Cleaning Your Blender section).  To prolong the life of your 

smoothie maker, 

do not wash parts in the dishwasher

. 

1.  Screw blade base on the bottom of the blending jar by twisting the blade base 

counter-clockwise until tightened.  Make sure that the blade base is tightly 

fastened to the blending jar and that the rubber gasket is properly compressed 

between the blending jar and the blade base. 

2.  Press the lid onto the top of the blending jar.  Press the clear lid cap in the 

center of the lid or place the stir stick through the center of the lid if blending 

liquids or frozen drinks. 

3.  Place the blending jar onto the motor base so that the bottom of the blade base 

is sitting flat on the motor base. 

4.  Plug in the cord.  Your blender is now ready to use. 

•

Note

:  The rubber gasket on the blade base is not removable. 

Stir Stick 

Lid Lid 

Cap 

Blending Jar 

Dispensing Valve 

Motor Base 

Rubber Gasket 

Blade Base 

5