BackYardCity Pool Bermuda Assembly & Installation - page 28

Do  not  place  the  liner  wall  seam  directly  over  the  skimmer  or  skimmer  return  cutouts.

Place the liner at the center of the pool with the flap from the seams facing down.  (For print liners, leave the

print  side  facing  up.)   Spread  the  liner  so  that  the  bottom  seam  of  the  circumference  is  resting  on  the  cove

evenly around the pool.  The seam should not be up on the wall or shifted to one side.  These conditions will

cause tightness or stretching of the liner when the pool is being filled.

CORRECT LINER SEAM

Resting evenly on or near the cove

of the pool. Seam may not always

lie on the cove as pictured, so your

focus should be to keep the seam

consistent around the pool.

INCORRECT LINER SEAM

Shifted up wall. 

This should not be done.

Correct this situation 

if it occurs.

POOL WALL

COVE

COVE

STEP 19- LINER INSTALLATION: 

*Find the center point of each end of your liner and make sure you line     

that up perfectly with the center point of each end of your pool.

*NOTE: Line wall seam straight up and down, away from skimmer and skimmer return.

Fig. 56

Fig. 57