BackYardCity Pool Bermuda Assembly & Installation - page 33
2 PC RESIN TOP COVER
: Center small half over hole in
the top plate as shown and attach with a #12 screw.
Slide the large half over the small half and secure
using two #10 screws.
ONE PIECE RESIN CLIP-ON COVER
: This installation
requires no hardware. Simply hook the back end of
the top cover into place, and use your fingers or a
screwdriver to gently flex the front tabs enough to
hook the cover in place. Make sure that the top cover
is centered over the upright when installing.
Side view of top
cover and top rail
Swing this end around and
gently flex tab into place.
Bullnose rail is used for the illustration, but installation is
the same for all 1 pc. clip-on resin covers.
Hook this
end first.
#12
*ON 6” TOP RAIL POOLS WITH 2 PC. TOP COVERS, THE CURVED AND STRAIGHT SIDE COVERS ARE THE SAME.
STEP 24 – TOP COVER INSTALLATION:
#10
#2
#12
#10
STRAIGHT SIDE SUPPORT
Used on the straight side of
the pool-notice the square
cutout. Use on oval uprights.
Fasten bottom half of top cap to upright using #10 screws.
Secure top half to bottom half using #12 screws.
CURVED SIDE ANGLE SUPPORT:
Use on curved end upright.
TOP VIEW OF STRAIGHT
SIDE SUPPORT:
Smaller piece that is
open in back. Use on
oval uprights.
TOP VIEW OF CURVED SIDE
ANGLE SUPPORT:
Larger than straight side
support. Has back wall.
Use on curved end uprights.
No back wall
TWO PIECE RESIN TOP COVER WITH ATTACHMENTS ON THE
SIDES
: There is a straight support with a square cutout
to fit the oval upright, instead of an angle support
supplied for the curved ends. It attaches the exact same
way as the angle support.
LARGE TWO PIECE RESIN TOP COVER WITH ATTACHMENT
IN FRONT
: (DOES NOT INCLUDE 6”T
OP RAIL
POOLS.) The curved end angle support is slightly
larger than the straight support. The straight support is
not filled in the back.
Back wall
1)
Attach the inner top cap using a #12 Screw into hole #2.
2)
Attach the resin outer Top Cap using a #12 screw into hole. Put the
grill over the screw when finished. See Diagram below.
#12 screw
Small Half
Inner Cap
#12 x 3/4” screw
Top Cap Grill
Curved and Top Cap