Bajaj Storage Water Heater User Manual - page 3
bajaj electricals limited Page 3 of 6
NON-RETURN DEVICE: There is a siphon hole on the inlet pipe inside the inner tanks of all Bajaj Storage Water
Heaters. When pressure inside the tank becomes low, this siphon hole prevents back flow of water. It acts as a non
return device upto a certain level of low pressure. Thus it prevents collapse of the tank due to vacuum formation.
BENEFITS
1.
A two-year guarantee.
2.
Attractive colours in two tone powder coated finish.
3.
Suitable for single point usage.
4.
The largest dealer and After Sales Network available in the country.
5.
Rust resistant Stainless Steel Hardware facilitates easy servicing.
THE HOW AND WHERE OF INSTALLATION AND OPERATION
A.
Fix the Water heater in a perfectly straight position at a suitable height
from the floor.
B.
There should be enough space around the heater for easy installation and
servicing.
C.
Make sure that supporting walls or fixture are strong enough to carry the
weight of the heater when it is completely filled with water. A typical
installation (for vertical and horizontal mountings) is shown in Fig. 2,3,4
&5. For overall and mounting dimensions please refer the technical
specifications table.
D.
There should be a minimum space of 50 cm between the top of the heater
and the roof. This is to make sure that the heater can be removed and
taken out when necessary.
E.
The heater should be saved from being damaged by splashing of water.
Therefore, keep a minimum space of about 1.8 m. between the floor and
bottom of the heater.
F.
When the mounting is horizontal, keep a minimum space of 50 cm between
the wall and inlet/outlet pipes so that parts can be easily removed for
servicing etc.
WATER SUPPLY
A.
You can connect the heater directly to municipal water supply or vent pipe
above the water-tank on top of your house.
B.
If the height is more, use a Pressure reducing valve at the inlet.
C.
The water pressure should also not be too low. The minimum distance between the heater and the water
supply tank should be at least 2 meters.
D.
YOU SHOULD INSTALL THE VENT PIPE FROM THE TOP OF THE HEATER ABOVE THE LEVEL OF THE WATER
SUPPLY TANK. THERE, IT SHOULD BE LEFT OPEN TO THE ATMOSPHERE. THIS IS THE SAFEST METHOD OF
INSTALLATION.
WATER CONNECTIONS
Do not connect the cold and hot water pipe lines directly to the heater. Instead, connect them using flexible tubes of
appropriate material. Never use plastic tube especially at the outlet because it cannot withstand the heat. In case of