Bajaj Storage Water Heater User Manual - page 6
bajaj electricals limited Page 6 of 6
1.
Read Installation and Operating instructions carefully.
2.
Get a qualified plumber/electrician to install the unit.
3.
THE INLET VALVE SHOULD ALWAYS BE KEPT OPEN.
4.
To minimise scaling of heating element, which happens more in areas with hard water, simply lower the
setting of the thermostat a little. Drain the water periodically. However this should be done through a
qualified technician only.
5.
Scaling of the heating element can be removed by scrapping.
6.
Always get the unit serviced once in two years.
7.
Use genuine spare parts when replacement is necessary.
8.
Switch OFF the power supply to the unit and drain out the water when the heater unit is not in use. This
prevents scaling of element and increases its life.
9.
In case the red lamp glows ON do not operate the unit by resetting the thermal cut-out. Please
contact the nearest Bajaj Sales and service station to check if there is a fault.
10.
Always drain out the water when i) the unit has to be serviced OR ii) When the unit is not in use. Use the
drain pipe provided separately to drain out the water.
11.
In case of any problem with the heater contact the nearest Bajaj sales or service centre.
12.
Be very sure that you do not increase the setting of the thermostat more than the pre-fixed temperature.
DON'TS
1.
Safety valve, thermostat and thermal cut-out are used to control temperature and pressure.
These are very sensitive and pre-set devices. Do not tamper with them or try to change their
settings. This could prove hazardous and should be strictly avoided.
2.
Do not switch ON the beater till it is completely filled with water.