Balance Meteo LED Weather Station User manual - page 5
Close the battery compartment of outdoor sensor.
The transmission LED
on the front of the outdoor sensor will start to flash for
10 seconds. The default flashing frequency is once per around 2 seconds to
indicate this sensor will be registered on channel 1 if not set manually within 10
seconds.
While the transmission LED is flashing, press once the [CH] button
at the
bottom of a remote sensor and it will flash twice per around 2 seconds to
indicate this sensor will be registered on channel 2. Keep toggle on [CH]
button can change channel setting up to 3 and then back to channel 1.
3. Backup battery and adaptor installation for main unit
Take away the removable stand
from the weather station.
Open the battery compartment on the rear of the weather station.
Install 2 pieces of AAA sized batteries according to the polarity mark inside the
battery compartment.
Close the battery compartment
Put back the removable stand and place the weather station securely on a
flat surface; or mount it on a wall without the removable stand
Insert the plug of the AC/DC adapter into the DC 5V IN jack
of the weather
station and connect the adaptor to a wall outlet (100-240V AC).
When the weather station is powered on, it will initiate the RF search mode to
search if there is/are any remote sensor(s) within 100 feet (30 meters).
Once a remote sensor is registered, this LED weather station will display its
temperature in the corresponding remote channel.
Note: This LED weather station must work with the adaptor. If the user removes the