BALCO KOG6789 Instruction Manual - Installation
21
After Sales Support
1300 663 907
Model Number
KOG6789
customercare@balcolifestyle.com.au
1.4 Unboxing and Assembly
Your Balco 3D Printer is packed tightly and carefully -- take your time unpacking it.
To view a step by step video of the Unboxing and Assembly, visit balcolifestyle.com.au
1. Place the Control Box, Extruder Tower and Heated Print Bed on a
clean, level work space. Carefully remove the cable tie that holds the
Extruder in place
2. Insert the Heated Print Bed lengthways between the legs of the
Extruder Tower and align the bolt holes on each side. Using the Hex
Wrench, insert and tighten the two external bolts. Place printer on its
side, then insert and tighten the two internal bolts
3. Carefully cut the cable tie on the left side of the Heated Print Bed.
Then, on the left side, insert the long cable connector marked ‘A’ into
the motor connector of the Extruder Tower marked ‘A’
4. On the left side, insert the short cable connector marked ‘B’ into the
motor connector of the Extruder Tower marked ‘B’
5. On the left side, insert the connector marked ‘C’ into the connector of
the Extruder Tower marked ‘C’
Installation
.