BALCO KOG6789 Instruction Manual - Installation
25
After Sales Support
1300 663 907
Model Number
KOG6789
customercare@balcolifestyle.com.au
Installation
1.5.3 Default Configuration
The following settings show the default configuration values of the Balco 3D Printer. We’ve set
these to provide optimal quality for your 3D printed models, however, if you wish to adjust these
settings, we recommend this to be done by only highly experienced users, as print quality and 3D
printer durability may be affected.
• General
Baudrate: 115200
Stepper Inactive: 360s
Max Inactive: 0s
• Acceleration
Print X: 1000
Print Y: 1000
Print Z: 100
Move: X
Move: Y
Move: Z
Jerk: 20.0
Z-Jerk: 0.3
• Feedrate
Max X: 200
Max Y: 200
Max Z: 2
Home X: 40
Home Y: 40
Home Z: 2
• Extruder
Steps/mm: 96.0
Start FR: 20
Max FR: 50
Accel: 5000
Stab. Time: 1
Wait Units: 0mm
Wait Temp.: 150C
Control: Dead Time
DT/PID P: 7.00
PID I: 2.00
PID D: 40.00
Drive Min 40
Drive Max 230
PID Max: 255
• Store to EEPROM: Save configuration settings to the internal storage, to be re-loaded on
reboot
• Load f. EEPROM: Return configuration settings to the last reboot
.