Baldor MotiFlex e100 Installation Manual - Product Notice
www.baldormotion.com
1-2 General Information
MN1943
Product notice
Only qualified personnel should attempt the start-up procedure or troubleshoot this equipment.
This equipment may be connected to other machines that have rotating parts or parts that are controlled
by this equipment. Improper use can cause serious or fatal injury.
Safety Notice
Intended use: These drives are intended for use in stationary ground based applications in industrial
power installations according to the standards EN60204 and VDE0160. They are designed for machine
applications that require variable speed controlled three-phase brushless AC motors. These drives are
not intended for use in applications such as:
H
Home appliances
H
Medical instrumentation
H
Mobile vehicles
H
Ships
H
Airplanes.
Unless otherwise specified, this equipment is intended for installation in a suitable enclosure. The
enclosure must protect the equipment from exposure to excessive or corrosive moisture, dust and dirt or
abnormal ambient temperatures. The exact operating specifications are found in section 3 and section 8
of this manual. The installation, connection and control of drives is a skilled operation. This equipment
contains no user-serviceable parts; disassembly or repair must not be attempted. In the event that the
equipment fails to operate correctly, contact the place of purchase for return instructions.
Precautions
Do not touch any circuit board, power device or electrical connection before you first
ensure that no high voltage is present at this equipment or other equipment to which it is
connected. Electrical shock can cause serious or fatal injury. Only qualified personnel
should attempt to start-up, program or troubleshoot this equipment.
The motor circuit might have high voltages present whenever AC power is applied, even
when the motor is not moving. Electrical shock can cause serious or fatal injury.
After AC power has been removed from the MotiFlex e100, high voltages (greater than
50 VDC) can remain on power connections for up to 5 minutes, while the DC bus circuitry
discharges. Do not touch the DC bus, regeneration resistor, or other power connections
during this period.
If a motor is driven mechanically, it might generate hazardous voltages that are conducted
to its power terminals. The enclosure must be earthed/grounded to prevent possible shock
hazard.
Be sure the system is properly earthed/grounded before applying power. Do not apply AC
power before you ensure that earths/grounds are connected. Electrical shock can cause
serious or fatal injury.
Be sure that you are completely familiar with the safe operation and programming of this
equipment. This equipment may be connected to other machines that have rotating parts or
parts that are controlled by this equipment. Improper use can cause serious or fatal injury.
DANGER
DANGER
DANGER
DANGER
DANGER
WARNING