Balluff BNI EIP-502-105-Z015 User Manual - page 18
www.balluff.com
17
8
Webserver
8.1.
General
The BNI EIP-502 module includes an internal webserver to get detailed information about
the current state. Also you can use it to configurate the module and the connected IO Link
devices.
First make sure that a correct integration into your network has been done. To get a
connection to the webserver enter the IP address of the module to your browser address
bar. A welcome page with a list of all Balluff Ethernet Network-interfaces is shown.
Please use Internet Explorer 7 or higher.
8.2.
Home
By click on “play”-button “Home” active.
You can get some information about the configuration and network-activity of the module.
At the top of the window you can see the navigation bar which allows you to switch between
the different webpages, just click on the corresponding text.
8.3.
Diagnostic
Process
On this page you can get some information about the module’s current process data by
having a look at the leds.
If a IO Link Device is connected to one of the IO Link ports some device data is shown
besides the module
. You can use this text or the port on the module as a link to “Device
properties”.
8.4.
Device Properties
On this page you can get information about the IO Link device that is connected on the
selected port. Also it is possible to configure the device by using the read/write functions.
The indices and subindices which can be written or read are defined by the connected
device. So for this reason have a look at the IO Link device manual.
8.5.
Diagnostic
Module
On this page you can see the current module and network status like you can see it on the
module itself.
8.6.
Configurations
The configuration page allows you to configure the module. You can change network-
parameters and also assign own module information texts like a module description.
This can only be used by entering a username and a password:
Username:
Balluff
Password:
BNIEIP